What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
16.06.2025 00:31

First Sentence:
It also is a device that limits the change in current flow.
So, the voltage could go up to 500 volts, and the fuse will not open up.
How were cows used in ancient India?
It seems Mohan does not understand the difference between a comment and an Answer.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
Barnstars:
[old diagram got deleted by accident]
I post the exact comment here.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
How do I get over a long-term relationship breakup?
A fuse is a non-resetable over current circuit protector.
The other is “what does a “fuse” do?”
At one ohm, the resistor has a maximum of 1 watt power.
If white people had been slaves, would WLM be a thing right now?
At least they know the answer if they wanted it.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
nine
What is the meaning of "ero" in Japanese?
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
There are three different concepts here that are getting confused.
What are the pros and cons of living in Male, Maldives?
But… the neutral is now “floating” because of the 1 ohm resistance.
what exactly is a ‘surge’ protector?
This is the picture of an electronic coil of wire wound around a core of magnetic material.
What are the popular niches to talk about as a content creator on the social media platform?
An AC voltage/ current source, and an ac inductive load.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
Kennedy’s HHS sent Congress ‘junk science’ to defend vaccine changes, experts say - CNN
One is “what exactly is in a ‘surge protector’ ? ”
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
These are simplified answers to the original question, and does not change anything I wrote above.
What is lightning?
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
Why do companies cull employees during financial downturns without saying so?
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
Here is a simplified AC power diagram.
a photo is worth a thousand words.
Do all therapists specialize in one specific type of therapy, or are they trained in multiple types?
This one hit behind the barn.
[image of Common-mode choke]
2024–10–14 [Omar Gharbi Omar Gharbi ]
Can the fuse protect the electronic devices from lightning instead of a surge protector.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
The bolt then partially travels down the line to your home.
Is it true that in 2028 there will be a new AIDS variant that will wipe out all the LBGTQ+ people?
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
The third is lightning and “how it gets conducted into a home.”
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
but I think this circuit , shows a few more pieces.
He then describes Rainy Season and Lightning.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
eight
The MOV will conduct when the voltage exceeds 50% of line voltage.
These devices are installed between the “hot” and “neutral” and protective ground.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
He then asserts :
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
Upvotes:
This is where the MOV conducts again, and dissipated the energy.
so, what happens?
But it can get overloaded, and no longer works.
This is where this question deviates from being a 'generic' question, and becomes more specific.
Edit 2024–10.
the problem then depends on "how fast does the fuse operate?".
This device then solves the entire problem.
He then describes the function of a fuse.
For this case there are devices called Metal oxide varistors (MOV).
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
One
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
2024–10–10[John johnson John Johnson ]
2024–10–16 [ OO OLAOYE OYEBODE ]
In schematic diagrams this is the symbol for a fuse:
but this device (an Inductor) … impedes the rapid changes in the current.
(Dc diagram shown, AC is similar).
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
A circuit breaker is similar, but is resettable.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
There are two important concepts here.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
What does a fuse do?
Because the load is inductive, the current lags the voltage.(by a bit).
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
This is 'the assistant's answer'
Now when you have a certain ac resistance, then a current flows in a loop.